![]() Non-Slip, Positive Performance - Belt-pulley compatibility and close manufacturing tolerances assure those belt teeth mesh precisely with pulley grooves for constant output speed without skipping, vibration or speed variation.Popular Profiles – Available in the high torque, low noise STS profile, the widely used HT curvilinear profile and the traditional Trapezoidal profile.Bando timing belts offer these advantages: When synchronization of the driveN and driveR speed is required, Synchro-Link ® Timing Belts give unsurpassed efficiency, economy, and performance and are available in both inch (RMA) and metric dimensions. High Thermal Conductivity Sheet: HEATEX™.Synchro-Link® Trapezoidal TL® Timing Belt Pulleys.Synchro-Link® STS TL® Timing Belt Pulleys.Synchro-Link® Trapezoidal QD® Timing Belt Pulleys.Synchro-Link® HT QD® Timing Belt Pulleys.Synchro-Link® Trapezoidal MPB Timing Belt Pulleys.Synchro-Link® HT MPB Timing Belt Pulleys.Synchro-Link® Double-Sided Timing Belts - Polyurethane (Metric).Synchro-Link® Double-Sided Timing Belts - Polyurethane (ARPM). ![]() Synchro-Link® Double-Sided Timing Belts - Neoprene.Synchro-Link® Timing Belts - Polyurethane (ARPM).Synchro-Link® Timing Belts - Polyurethane (Metric).A belt drive with the requirements and in the opposite direction, require special compact installation location, or in the main drive and auxiliary transmission linkage and other areas of high transmission requirements, reflects its excellence product lightweight, non slip gear drive, low noise characteristics by the wide machinery, textile, precision instrumentation, petroleum chemical industry, communications cable industry awareness, has been widely recognized. The product is mainly used for double side transmission, with synchronous, simultaneous, double efficiency characteristics. The pitch and tooth profile of the product are the same as those of single tooth. The belt body used Japanese imports of high-quality synthetic chloroprene rubber, and mixed with a variety of different uses of rubber materials skeleton materials for high quality glass fiber cord imported from Japan with tooth surface with high elastic nylon cloth 66 protection. Material selection and product characteristics ![]() It is strictly prohibited to use the non professional tools to pry down under the condition of high tension. The specification, model and size of double tooth synchronous beltġ)Note that the product surface is clean, the belt should not be distorted, with teeth to be full.Ģ)Products in the transport, installation and other processes, no twists and turns, otherwise it will damage the skeleton material (glass fiber), the impact of the strength of the belt.ģ)Products in the installation and use of the process, shall not scratch the belt, not with chemicals (especially strong oxidizing acid), try to avoid contact with oil and water for a long time, so as not to affect the life of the product.Ĥ)When the product is replaced, the tension of the belt must be reduced to the minimum, so that it can be taken out. The pitch and the tooth profile of the double toothed synchronous belt are equal to the tooth profile and pitch of the single tooth synchronous belt.Īccording to the arrangement of double tooth synchronous belt with teeth can be divided into two types: standard type DA double tooth synchronous belt, the two sides with teeth symmetrically arranged, see figure (a) DB type double tooth synchronous belt, the two toothed staggered arrangement, see figure (b)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |